Laser AT-1
Features:
Noise, wear on pulleys, belts and bearings, vibrations and in the end ... machine downtime may all be caused by improper pulley alignment. This can be prevented by using Gates' new laser alignment device, the LASER AT-1.

The current method to measure misalignment is putting a straight edge up to the pulleys. A much faster and more accurate method is ensured by Gates' unique laser alignment device, LASER AT-1. Mounted in a few seconds, the laser line projected on the targets allows you to quickly ascertain and correct misalignment. The LASER AT-1 identifies parallel as well as angular mis alignment between the pulleys and is suitable for pully diameters of 60 mm and larger. It is so light it can be mounted on non-magnetic pulleys with the double sided adhesive tape and used on both horzintally and vertically mounted machines.
  • •       For both V-belts and synchronous belts
  • •       Shows parallel and angular misalignment between the pulleys
  • •       Much faster and more accurate than measuring with earlier, conventional methods
  • •       For both horizontally and vertically mounted machines
  • •       Alignment can be made by one operator
  • •       Also suitable for non-magnetic pulleys
Alignment
     
Technical  Characteristics Pulley diameters ≥60mm
Beam angle 78°
Measurement distance 10m(33 ft)
Battery 1 x R6(AA) 1.5V
Battery operation 8 hour continuously
Laser class 2
Output power < 1 mW
Laser wave length 635-670nm
Temperature range -10°C up to +50°C
Housing ABS plastics
Back plate Anodised aluminium
Weight 0.25 kg
Dimension W 147mm x H 87mm x D28 mm
Calibration accurary OffSet < 0.5 mm
Angle < 0.1°
Targets 2 pieces magnet targets with adjustable centre line
Light weight Because of its light weight it can be mounted on
non-magnetic pullys with double-sides adhesive tape